INSTALLING THE STEERING SERVO
(NOT INCLUDED)
1.
Mount the servo SX107 with the output shaft toward the left side of the chassis a as
shown in the image below.
2.
Center the steering servo using a servo checker. If no servo checker is available, the servo
can be centered with the radio system. Power on the transmitter and ensure the steering
trim is centered. Plug the servo into the receiver. Power on the receiver. The servo should
power on and move to center.
3.
With the servo centered, install the recommended (LOS311010) servo horn so the ball is
90 degrees as shown in the image below.
NOTE:
The included aluminum servo horn requires a servo with a 20T output gear.
1.
Install servo tape to the receiver.
2.
Install the receiver to the chassis.
3.
Refer to transmitter/receiver manual for binding
instructions.
INSTALLING THE RECEIVER (NOT INCLUDED)
Receiver sold separately
4.
Connect the steering linkage to the ball on the servo arm.
5.
Connect the other end of the steering linkage to the ball on steering rack.
6.
Connect the servo wire to the steering port on the receiver.
EN
4
LOSI MINI-B 2WD BUGGY PRO ROLLER • INSTRUCTION MANUAL