SPEKTRUM STX2 RADIO SYSTEM
1. Steering Wheel
Controls direction (left/right) of the model
2. Throttle Trigger
Controls speed and direction (forward/brake/reverse) of the model
3. ON/OFF Switch
Turns the power ON/OFF for the transmitter
4. Throttle Limiting Switch
Adjusts the throttle limit from 50%, 75%, and 100%
5. TH Rate
Adjusts the end point of the throttle
6. TH Trim
Adjusts the throttle neutral point
7. TH REV
Reverses the function of the speed control when pulled back or pushed forward
8. ST REV
Reverses the function of the steering when the wheel is turned left or right
9. ST Trim
Adjusts the steering center point
10. ST Rate
Adjusts the end point of the steering
11. Antenna
Transmits the signal to the model
12. Indicator Lights
-
Solid red light
—indicates adequate battery power
-
Flashing red light
—indicates the battery voltage is critically low. Replace batteries
INSTALLING THE TRANSMITTER BATTERIES
For more information on the transmitter, go to www.horizonhobby.com and click
on the support tab for the Spektrum STX2™ transmitter to download the instruction manual.
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Reinstall the battery cover.
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries.
Charging non-rechargeable batteries may cause the batteries to burst, resulting
in injury to persons and/or damage to property.
CAUTION:
Risk of explosion if batteries are replaced with an incorrect type.
Dispose of used batteries according to national regulations.
2.4GHZ DIGITAL
RADIO SYSTEM
1
2
11
3
4
8
7
9
6
10
5
12
BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique
Identifier) code of a single specific transmitter. The STX2™ and SPMSRX200 receiver are
bound at the factory. If you need to rebind, follow the instructions below.
1.
With the vehicle on a flat, level surface, insert the Bind Plug in the BIND port on the
receiver.
2.
Connect a fully charged battery pack to the ESC.
3.
Power on the ESC. The red LED flashes, indicating the receiver is in bind mode.
4.
Center the ST TRIM and TH TRIM dials on the transmitter.
5.
Turn the steering wheel to Full Right. Power the transmitter on while holding the steering
wheel to the Right.
6.
Release the steering wheel when the receiver LED stops flashing.
7.
Remove the Bind Plug, then power off the receiver to save the settings.
8.
Power off the transmitter.
9.
Remove the bind plug and store it in a convenient place.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle or steering reversing has been
changed.
• Binding the receiver to a different transmitter.
CHANGING THE THROTTLE LIMIT
The throttle limit switch enables you to limit the full throttle position without adjusting the
throttle travel adjustment.
Move the throttle limit switch to 50% or 75% for less experienced drivers or when you are
driving the vehicle in a small area.
When you move the Throttle Limit switch to 100%, the full throttle position is equal to the
high Throttle Travel position.
Throttle Limit Switch
5
EN
EN
5
LOSI MINI 8IGHT-DB RTR • INSTRUCTION MANUAL
