EN
4
LOSI 8IGHT-E RTR • INSTRUCTION MANUAL
SPEKTRUM DX2E RADIO SYSTEM
LOSI 8IGHT-E RTR • INSTRUCTION MANUAL
4
INSTALLING THE TRANSMITTER BATTERIES
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the
transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries.
Charging non-rechargeable batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to national regulations.
For more information on the transmitter, go to
www.horizonhobby.com
and click on the
support tab for the Spektrum DX2E to download the instruction manual.
1.
Steering Wheel
Controls direction (left/right) of the model
2.
Throttle Trigger
Controls speed (forward/brake) of the model
3.
BIND Button
Puts the transmitter into Bind Mode
4.
ON/OFF Switch
Turns the power ON/OFF for the transmitter
5.
ST REV
Reverses the function of the steering when the wheel is turned left
or right
6.
Indicator Lights
-
Solid green light
—indicates adequate battery power
-
Flashing green light
—indicates the battery voltage is critically low.
Replace batteries
7.
TH REV
Reverses the function of the speed control when pulled back or pushed forward
8.
ST Trim
Adjusts the steering center point
9.
TH Trim
Adjusts the throttle neutral point
10. ST Rate
Adjusts the steering limits
11. Antenna
Transmits the signal to the model
1
2
11
4
10
7
8
5 6
3
9
BINDING AND CALIBRATING THE RECEIVER
The included transmitter and receiver are bound at the factory. To rebind:
1.
Power off the transmitter and receiver.
2.
Insert the bind plug into the BIND port on the receiver.
3.
Power on the receiver. The LED in the receiver flashes rapidly, indicating that the receiver is
in bind mode.
4.
With the throttle in neutral, power on the transmitter while pressing the bind button. The
LED in the receiver turns solid when binding is complete.
5.
Remove the bind plug from the receiver after binding is complete.
You must rebind when binding the receiver to a different transmitter.
NOTICE:
Do not attempt to bind the transmitter and receiver if there are other
compatible transmitters in bind mode within 400 feet. Doing so may result in
unexpected binding.
BATTERIES AND CHARGING
Your vehicle uses rechargeable Li-Po batteries. These batteries all have special requirements
to preserve performance.
• Read all instructions provided by the manufacturer of the batteries.
• Never allow minors to charge battery packs.
• Always check to ensure the polarity of the battery connection is correct.
• Never leave batteries unattended while charging.
• Never charge a battery while it is installed in the vehicle.
• Do not charge any battery that appears to have any damage.
• If there are exposed wires, do not charge or use the battery until you install shrink-wrap
or replace the complete wire.
When charging Li-Po batteries, select a charger to meet your requirements. You need
a charger that is a 100–240V wall charger or one which requires a 12V power supply.
Follow the charger manufacturer’s instructions and precautions during each use.
