Team Kalorik TKG GBBQ 1003, Руководство пользователя

Страница: 18 / 47

18
GBBQ 1003
- 190108
Burner will not light
using ignitor
Electrical issues:
1. Electrode cracked or
broken;” sparks at
crack.”
2. Electrode tip not in
proper position
3. Wire and/or electrode
covered with cooking
residue.
4. Wires are loose or
disconnected
5. Wires are shorting
(sparking) between igitor
and electrode.
6. push button sticks at
bottom sparking
between ignitor and
electrode
1.Replace electrode.
2.Tip of electrode should be pointing toward
port hole in burner. The distance should be 1/8”
to 3/16”. Adjust if necessary
.
3.Clean wire and or electrode with rubbing
alcohol and clean swab.
4.Reconnect wires or replace electrode/wire
assembly.
5.Replace ignitor wire
6.Replace ignitor
7.Inspect wire insulation and proper
connection. Replace wires if insulation is
broken.
Burner will not mach
light
See ”gas issues;” on
previous page.
2. Improper method of
match-lighting
1. See “Pilot Gas Control Ignition” section of use
and care.
Sudden drop in gas
flow or low flame 1. Grease buildup.
2. Excessive fat in meat.
3. Excessive cooking
temperature 1. Clean burners and inside of grill/ firebox
2. Trim fat from meat before grilling.
Flames blow out High or gusting winds.
Low on LP gas.
Excess flow valve
tripped.
Turn front of grill to face wind or increase flame
height.
Refill LP tank.
Refer to “sudden drop in gas flow” above.
Persistent grease fire Grease trapped by food
buildup around burner
system.
Turn knobs to OFF. Turn gas off at LP tank.
Leave lid in position and let fire burn out. After
grill cools, remove and clean all parts
Flashback…
(fire in burner tube(s)
Burner and burner tubes
are blocked Turn knobs to OFF. clean burner
and/or burner tubes. See burner cleaning
section of use and care manual
Flare-up 1. Grease buildup.
2. Excessive fat in meat.
3. Excessive cooking
temperature
1. Clean burners and inside of grill/ firebox
2. Trim fat from meat before grilling.
3. Adjust (lower) temperature