TeachLogic VoiceLink I, Руководство пользователя

Страница: 20 / 28

owner’s manual
14
VoiceLink I
projector system setup
•
With the corner sensor installed, connect it to
VoiceLink I
•
Locate VoiceLink I near projector and connect to
AC power
•
Connect an audio cable with 3.5mm connectors
from projector audio output to VoiceLink I Aux
In (front panel)
•
Connect VoiceLink I output to power amplifier
•
Shielded audio cable with RCA phono from
unbalanced output to amplifier input
•
Shielded two-conductor cable connected
per balanced output per page 11
•
Turn "on" VoiceLink I, Power Amplifier, and
Video Projector
•
Set “AUX IN” control on VoiceLink I to 2 o’clock
position
•
Set power amplifier volume (if applicable) mid
scale
•
With microphone turned “on”, speak and adjust
microphone volume using “MIC” volume control
on VoiceLink I
•
With an Auxiliary program turned “on” and
plugged into the projector, adjust the auxiliary
volume with the remote control
•
Some adjusting of the VoiceLink I (AUX) and
amplifier volume may be required
•
Once auxiliary volume is optimized, readjust
microphone volume using “MIC” volume control
•
System is now ready to use with remote control
of AUX inputs and consistent Mic volume
(Mic volume does not change with remote
volume control)
Microphone volume is
not affected by the remote
control of the auxiliary
inputs.
note
How to Interface VoiceLink I with a Video Projector and
incorporate the Projector’s Remote Control
AUDIO OUT
REMOTE
SENSOR
Infrared Transmitter
”Crescent”
Speaker
Projector
Remote
Control
POWER
INFRARED MIC
VoiceLink I
IR Sensor