Fi
W
to the amplifier, we are ready to complete the installation.
e sensor input
s.
ables because the two channels
will be
d insert the
RED
wire to either outside screw terminal. Insert
other wire into the next slot. Tighten the setscrew.
•
Do same with the other speaker cable.
nal Connection of the System
ith all the two speaker wires and sensor cable neatly routed
•
Connecting the Dome Sensor
•
Plug the sensor cable into either of th
jacks (RCA)
•
Coil up the excess cable (if applicable) and place it
out of the way and view
•
Connect the auxiliary audio sources
•
The auxiliary input jacks are dual RCA phono jacks.
They are labeled on the back corresponding to the
volume control on the front panel. Connect each
source using a shielded cable with RCA connector
•
You can use stereo c
will be summed internally so both channels
passed through as a combined monaural signal.
Connecting the Speakers
•
Cut the speaker wires to the proper length.
•
Split the cable and strip approximately
⅜
-
½
” off
each wire.
•
Twist the stranded wire and if you have a soldering
iron available, it is a good practice to tin the wire
ends.
•
It is important to observe speaker polarity (note
m II).
speaker diagram on back panel of Maxi
•
Unplug the phoenix block connector an
Содержание Maxim II
Страница 1: ......
