TeachLogic Matrix IMA-121, Руководство по установке

Страница: 17 / 23

Matrix
™
Final Setup
16
www.teachlogic.com | support@teachlogic.com | (760) 631-7800
16
Maxim
™
III Security Alert Interface
To change the mode:
Whether mode is 1-pulse or 4-pulse, the steps below will change it to the other mode.
1. If power state is ON (Blue LED at power button), press once to set power state OFF (Red LED). If Red, then you may
start the mode switching process.
2. Locate the RS-232 on/off switch on the back panel.
3.
Press and hold the front panel power button (in Red state) for the duration of the mode switching process. (Figure 3
below)
4. Move the RS-232 switch from ON to OFF and back again FIVE times. Then release the front panel power button.
(Figure 4 below)
The process requires 5 full cycles of the RS-232 switch while the power button in Red OFF state is held in.
Using the previous process, check the mode to confirm that the Maxim™ III is in the desired 1-pulse or 4-pulse mode. If
not, repeat the steps above to change the mode .