Teac w-865r, Руководство пользователя, Страница: 20 / 148

20
Parallel Recording
3 2 2
1 1
This function allows you to record the same material
simultaneously on both TAPE I and TAPE II.
Load tapes into both decks and press the PARALLEL REC
button to start recording.
< Before starting recording, check and correct the following by
performing steps
- on page 16.
Record direction, Reverse mode setting, Dolby NR setting,
Recording level, etc.
When everything is ready, get back into stop mode if the
deck is in another mode.
< During parallel recording, the PARALLEL indicator is lit on the
display.
< During parallel recording, only the following buttons work:
TAEP I deck: Stop ( H )
TAPE II deck: PAUSE, REC MUTE, stop ( H )
< Pressing the stop button ( H ) on either deck stops both tapes
at once.
7 1
Insert a cassette tape for playback into the TAPE I
compartment and a cassette tape for recording into the
TAPE II compartment.
Set the tape transport direction on both decks.
If the play/record direction indicator ( h or y ) on the display
points in the direction opposite to the one desired, press the
PAUSE button followed play button (
h or y ) corresponding
to the desired direction.
After changing the tape transport direction, be sure to press
the stop button (
H ) to get out of the pause mode.
< Be careful not to press play button whose arrow points in the
same direction as the indicator. Doing so will start playback.
< Set the REV MODE switch as required.
< You don’t need to adjust the recording level or set the Dolby
NR system, as both depend on the pre-recorded source tape.
Press either DUB START button to start dubbing.
For normal speed dubbing, press the NORMAL button.
For high-speed dubbing, press the HIGH button.
High-speed dubbing makes a copy at approximately two
times the normal speed. We recommend normal speed
dubbing for best audio quality.
3
2
1
Dubbing (from TAPE I to TAPE II)