Timer recording using G-CODE
◆
For timer recordings, clock, date, and stations must be
set correctly.
◆
Load a cassette with its safety tab in place
(see page 15) and with sufficient free space for the
recording.
R E C O R D I N G
c a s s e t t e s
Call the G-Code menu.
From your TV magazine, type in the number next to
the programme you want to record ...
... and confirm.
Decide if you want to record "Once", "Weekly" or
"Daily"...
... and confirm.
Switch your video off.
If you wish to make changes:
Move to the position you want to change using the
/
buttons.
Change the setting using the
/
or number buttons. If all
setting are ok, press ok, till you see “OK: confirm” in the bottom
line.
Confirm.
G-CODE
G-CODE
0-9:G-CODE NUMBER
:CORRECT
OK:CONFIRM MENU:END
G-CODE NUMBER
83077----
TMR
1
2
3
4
5
6
7
8
9
0
OPERATE
HOW OFTEN DO YOU WANT
TO RECORD THIS PROGRAM?
PR+/-:SELECT
OK:CONFIRM MENU:END
ONCE
WEEKLY(ONCE A WEEK)
DAILY(MON-FRI)
DAILY(MON-SAT)
DAILY(MON-SUN)
TIMER PROGRAM (ONCE)
PR
03
START TIME
21:20
END TIME
22:20
START DATE 14/04(SAT)
TAPE SPEED
SP
PR+/-:SET (AV)
0-9 : SETUP (PR)
/
:CORRECT
OK:CONFIRM MENU:END
◆
If you don’t have the
G-CODE numbers
see page 12 for the normal timer.
◆
If you have made a mistake, move back to the relevant position with the
button and change
the setting.
◆
If there is no programme location displayed under “PR” in the change menu, the video doesn’t yet
know the location number for the programme you want. Type it in and this will be stored for last
recordings.
◆
Should programming overlap, you get a warning.
◆
To cancel the recording press the button (stop) more than 5 seconds.
◆
G-CODE is a trademark applied for by Gemstar Development Corp.. The G-CODE system is
manufactured under license from Gemstar Development Corporation.
11
DVST2C1D-HB/H(148*210) 01.4.16 11:19 AM ˘
`
11
