Rear view of
FD-505
Configuring for Option
adapter if necessary
Pin indicator
stripe (red or blue)
Ground connector
connector
Use power connector
adapter if necessary
Flat
Traditional power connector
from PC power supply
Figure B
“ribbon” cable
Configuring Drive A: and Drive B:
Your Combo Drive can be configured in two ways at the time of installation.
You can choose either option.
Option
Drive A: = 5.25” (1.2 MB)
Drive B: = 3.5” (1.44 MB)
Option
Drive A: = 3.5” (1.44 MB)
Drive B: = 5.25” (1.2 MB)
Using an IBM PC compatible cable with a twist at the end connector (Figure C)
and the factory default strap settings 1 (shown in Figure D).
a) Connect the FD-505 Combo drive to connector A:
Connector A: is at the end of the cable as shown in the sketch.
b) Set the jumpers as indicated in Figure D.
c) Connect the ground cable if your system requires it.
Connector B:
A:
Pin
FD-505 Jumper Matrix
Default strap settings 1:
AB 2 =
BC 1 =
DE 2 =
EF 1 =
Figure C
I
Jumper
Block
Figure D
3.5” (1.44 MB) =
3.5” (1.44 MB) =
5.25” (1.2 MB) = A:
5.25” (1.2 MB) = B:
3
