Teac CRX313i, Руководство пользователя

Страница: 6 / 15

Before Setting Up the Unit
• Operate controls and switches as described in the manual.
• Before turning on the power, make certain that the power cord is properly installed.
• When moving the unit, be sure to first disconnect the AC power cord.
• Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances
such as electric heaters, on top of other stereo equipment that radiates too much heat, places
lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas.
Unpacking and Setting Up
• Remove the product from the carton and remove all packing material from the unit. We suggest
that you save the packing material, if possible, in the unlikely event that your unit ever needs to be
returned for service. The original carton and packing material is the only safe way to pack your
product to protect it from damage in transit.
• Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove any
labels or stickers from the back or bottom of the cabinet.
• Place your unit on a level surface such as a table, desk or shelf, convenient to an AC outlet, out of
direct sunlight, and away from sources of excess heat, dirt, dust, moisture, humidity, or vibration.
• Unwind the FM antenna and extend it to its full length. It must be fully extended to provide the best
FM reception.
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' at the bottom of the unit to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating rubber material
specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften,
and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we
strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and
home improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before
you place the product on fine wooden furniture.
Power Source
This product is designed to operate on normal 240V~50Hz AC power only. Do not attempt to operate the
unit on any other power source. You could cause damage to the product that is not covered by your
warranty.
4