Teac CD-W516EB, Руководство пользователя

Страница: 13 / 42

Rear Panel
TEAC CD-RW Drive User’s Manual 5
Rear Panel
Figure 3 illustrates the rear panel of the CD-RW Drive.
Figure 3. Rear Panel of the CD-RW Drive
S1: Reserved for factory use only.
analog audio output connector: You can use an audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments are
described in the following table:
CSEL/Slave/Master configuration jumper: The CD-RW drive includes
three pairs of jumper pins on the rear panel that allow you to set the drive to
CSEL, Slave, or Master mode. (For more information, see “Configuring the
CD-RW Drive” on page 7.)
interface connector: Use the included IDE interface ribbon cable to connect
the CD-RW drive to an IDE interface in your computer. (For more
information, see “Chapter 2. Configuring and Installing the CD-RW Drive”
on page 7.)
power connector: Connect the power connector to the +5VDC and +12VDC
power sources. The +5VDC terminal is on the left as you face the rear panel;
the +12VDC terminal is on the right. The two center terminals are ground
terminals. (For more information, see “Installing the CD-RW Drive” on
page 8).
FG: Frame ground. This is a ground connection for the CD-RW drive.
Pin Number Audio Signal
1 Left signal
2 Ground
3 Ground
4 Right signal
CSEL/Slave/Master interface
connector
power
connector
frame
ground configuration jumper
analog audio
connector
S1
TEAC16x10x40.book Page 5 Thursday, March 15, 2001 11:15 AM