CD-RW2000 — Additional features
6
Indicating and changing the
TRIM value
The trim values, used in synchronized recording and
track division (4.5, “Rehearsal” in the manual) can
now be viewed and set independently outside the
rehearsal modes using two new menus.
Previously these two values were identical, and could
only be set in rehearsal mode.
These menu items are
Sync_TXXXXf
and
Inc_TXXXXf
.
The maximum and values for these parameters
remain the same as previously (±125 frames on either
side of the original point, at 75 frames/second).
7
Meter peak hold time
A new menu item has been added to allow the meter
peak hold time to a chosen value. Previously this was
preset to 1.2 seconds and could not be changed.
The new menu allows peak hold settings of between
0.0 seconds and 2.5 seconds. There is also a
HOLD
setting, where peak readings are displayed and held
until the
MULTI DIAL
control is pressed or the
ENTER
key of the remote control unit is pressed.
8
New media types
The TASCAM CD-RW2000 now supports High
Speed CD-RW (4x to 10x) in addition to Multi Speed
CD-RW (1x to 4x) media.
9
Finalization and erase times
The time taken to perform finalization and erase
operations depends on the media used, as listed here:
• Finalization:
• Erasing discs:
CD-R media
8x
Multi Speed CD-RW
4x
High Speed CD-RW
8x
Multi Speed CD-RW
4x
High Speed CD-RW
8x
Printed in China
TEAC CORPORATION
Phone: (0422) 52-5082
3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan
