Rear Panel
TEAC CD-ROM Installation Guide
3
Rear Panel
digital audio connector:
Use a digital audio cable to connect this connector to
the digital audio input connector. Pin assignments are described below:
analog audio output connector:
You can use an audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments are
described below:
CSEL/Slave/Master configuration jumper:
The CD-ROM drive includes
three pairs of jumper pins on the rear panel that allow you to set the drive to
CSEL, Slave (default), or Master mode.
interface connector:
Use an IDE interface ribbon cable to connect the CD-
ROM drive to an IDE interface in your computer.
power connector:
Connect the power connector to the +5VDC and +12VDC
power sources. Pin assignments are described below:
Configuring the CD-ROM Drive
The CD-ROM drive features three pairs of jumper pins on the rear panel. By placing
the jumper on the appropriate pair of pins, you can set the drive to Master, Slave, or
CSEL mode. The factory default setting is the Slave position.
Pin Number
Audio Signal
1
Ground
2
Digital Out
Pin Number
Audio Signal
1
Left signal
2
Left ground
3
Right ground
4
Right signal
Pin Number
Power
1
+12VDC
2
0V
3
0V
4
+5VDC
CSEL/Slave/Master
interface
connector
power
connector
configuration jumper
analog audio
connector
digital audio
connector
CD-552Eshort.fm Page 3 Wednesday, May 14, 2003 10:29 PM
StockCheck.com
