Teac AG20D, Руководство пользователя

Страница: 19 / 30

REMOTE CONTROL INFORMATION
1. Display
Press this button to display the state of input source. And when listening to the FM broadcasting with RDS,
press this button to show PS, PTY, RT and RT.
2. Input Source
Choose the input as your desire, you can chosse DVD VIDEO1 VIDEO2 TUNER AUX and TAPE
3. Memory: Press it to store the broadcast station as a preset.
4. Auto
This button is used to select AUTO tuning for AM and FM stations.
5. /-
Tuner frequency up and down..
6. Cursor
- Vol +/-: decrease or increase the volume.
- /-: Press these buttons to select a preset channel during the tuner mode.
- Mute: Press this button to mute the sound, push again to cancel the mute function.
7.
Dimmer
Press this button to set the brightness of the front panel display.
8. CH Select
Select channels by pushing this button, then use volume key to balance speakers.
9. +/-
These keys are used for SPK SETUP and DELAY TIME, Treble and Bass adjustment.
10. Delay Time
Press this button to set the delay time for the Dolby digital/Dolby Pro Logic modes.
11. Surround Mode
Select surround modes: MOVIE and MUSIC.
12. Stereo
With the unit in the STEREO mode, only front left and front right speakers and Woofer are working.
13. Dolby PL II
When receiving Analog/digital PCM signal or 2CH Pro Logic, turn on this button then the playing is under
analog 5.1CH state.
14. Dynamic
Press this button repeatedly to reach your desired compression dynamic range.
15. Power
Push this button to turn the unit into standby mode, push it again to turn off the unit.
16. ST/Mono
Press this button to alternate between Stereo and Mono mode when listen to FM broadcast.
17. Band
Press this button to alternate between FM and AM.
18. Manual
This button is used to select MANUAL tuning for AM and FM stations.
19. APS
Allocates and memorizes radio stations automatically. ( Note : Hold this button down for more than 3 seconds to
activate
20. SUB Woofer On/Off: Push this button to turn on or off the subwoofer output.
21. Bass
Press this button for Bass adjustment, then press +/- key to adjust the level.
22. LFE Trim
Under the Pro Logic 5.1CH or DTS 5.1CH mode, press this button and adjust the volume to set the Low
Frequency output level
23. Input Mode
Select Coaxial, Optical or Analog Input mode in DVD, AV1 and AV2.
24. Treble
Press this button for Treble adjustment, then press +/- key to adjust the level.
25. Test Tone
To balance speakers in Dolby Digital or Dolby Pro Logic mode.
26. Bass Mode
Press this button to set the delay time for the Dolby digital/Dolby Pro Logic modes.
Select one of the two preset speaker configuration according to your speakers. (refer to page 17)
27. DTS/Dolby Digital
When playing 5.1CH source, and while you are enjoying Stereo, push this button to playback source in
DTS/DOLBY DIGITAL.
14