HL-2S Installation Manual
11
Troubleshooting
5
Power Input –
Utilizing the supplied 24V .75A supply, when connected at the
Receiver side, No Power Supply is necessary at the Transmitter side.
6
Power Indicator –
This light indicates that power is being supplied to the
unit. Connection of the (included) Power Supply should illuminate this light on both
Transmitter and Receiver Units.
7
HDCP Indicator –
Refer to Item (7) above.
8
HDBaseT Link Indicator –
Refer to Item (8) above.
9
IRDA Out –
Used for connecting to an Infra-Red Emitter for controlling a device
at this end. The IR Signal would originate from the Transmitter end either from a
Powered Pickup or an IR Pass-Thru. (See diagrams on pages 12 and 13)
10
IRDA In –
Used for connecting to a Powered Infra-Red Pickup Device (Xantech
compatible) via 3-conductor mini-jack, or to IR encoded signal for Pass-Thru to the
IRDA OUT at the Transmitter end. (See diagrams on pages 12 and 13)
11
Mini USB (Firmware Update) –
For Firmware updates (provided if
necessary) by Transformative Engineering. DO NOT attempt to connect this port for
any other reason. Loss of all operation may result.
12
HDBase-T Link Connection –
Refer to Item (1) above.
TROUBLESHOOTING
As mentioned previously, most malfunctions can be addressed by careful examination
of the Category cable terminations and suitability of the UTP cable itself. Once the
“Link” lights are on, this system is operating normally. Lack of function should be
traced to a failure in HDMI interconnection cables or device settings. If all this has been
examined with no resolution of your problem, please contact our Technical Support
Department at 781-769-6410 or via email at: [email protected].
