PROGRAM SETTINGS
Warning: Do not enter the program settings unnecessarily.
Press shift key for
15 sec
to enter the
PROGRAM
settings. Now lower display
shows
P-00.
Enter
P-00
by pressing set key.
For setting the
scale
value 001. (Press
UP
key to increase the value) i.e., the
number of counts per pulse.
Press
SET &UP key
for entering the next setting
i.e, P-01, P02...
Respectively
.
This process should be done for entering each setting value.
Enter
P- 01
for setting the
UP/DOWN count selection.
P-01→ 0,1 (Press
UP
key
to increase the value)
Enter
P-02
for START/STOP selection
P-02→ 0, 1
(Press
UP
key to increase the
value) i.e., to decide the START/STOP function either by connector or key pad.
(*it s not applicable for manual start/stop)
Enter
P-03
for setting the required function.
P-03 → 0,1,2,3
(Press
UP
key to
increase the value)
0► MANUAL START /STOP
1►AUTO START/AUTO RESET
2►AUTO START/MANUAL RESET.
3►JUST COUNTING
Enter P-04 for entering
AUTO RESET TIME.
P-03 → 1 TO 255 SEC’S (Press
UP
key to increase the value) i.e, the time taken to reset the value after the
function.
*Applicable only for auto start /auto reset function.
Enter P-05 for unit
RUN HOUR
function .*Read only
Enter P-06 for entering the display setting. P-03 → 0, 1(Press
UP
key to increase
the value) i.e, value in the lower display.
.
Enter P-07 for entering factory reset. i.e, to reset all the function. To reset function
it’s required to enter the value as
5
in P-07 setting.
After setting all requirements (*press SET if required) &SHIFT key, now display
shows END.