HDU-1 Small Meeting Space Connectivity Solution
11
Receivers Functions
3
Link Cable –
RJ45 Connection for UTP (CAT5e/6/6e/6a/7) wiring to Controller.
No power supply is required, as the Controller provides power over the UTP wire.
(See Page 10, Item 1 for optional power input).
4
HDMI Out –
Standard HDMI v1.4a connection. We recommend as short
an HDMI cable as necessary. HDMI Cables in excess of 4 Meters are not
recommended.
5
USB –
For connection of your USB Client device. (See Page 9, Item 7)
6
IR In –
Infra-Red pathway for sending IR commands to the Switcher’s IRDA
OUT port. This is sent over the UTP connection and decoded within the Switcher.
IT
IS IMPORTANT TO NOTE THAT THIS IS A
POWERED CONNECTION
, DESIGNED FOR
A “XANTECH”-TYPE PICKUP.
Utilization of this pathway as a “passive” IR inserter
MUST include the mini-jack dongle included in the accessory kit. IR commands
coming from a control system (Crestron, Control4, etc) must be routed thru the IR
dongle which is then connected to this input.
FAILURE TO DO SO WILL RESULT IN
NON-OPERATION OF YOUR IR.
Connection of a “Xantech” –type pickup may be
directly connected here (NO DONGLE) which will power the pickup and insert the IR
commands.
7
IR Out –
Connect a “Xantech”-compatible IR Emitter here to relay the IR
commands injected at the “IR In” port on the Controller (See Page 7, Item 9).
8
Audio Output –
Stereo signal path for audio injected at Controller Audio In (See
page 7 Item 4).
