Center
Contact
Holder
Center
Contact
Pin
Cable
Dielectric
Solder Here
with 60/40 Solder
408-8267
2 of 2
Rev B
Figure 3
2. Place the center contact in in the contact holder,
heat the center contact, and push it over the inner
conductor of the cable to rest firmly against the
cable dielectric.
3. Remove excess solder.
2.3. Crimp the Cable Subassembly to Housing
Subassembly
1. Insert the cable into the housing subassembly
and seat the cable firmly in the housing
NOTE
i
Be sure that the center contact enters the pre-
assembled housing contact.
2. Slide the outer sleeve over the flared portion of
the cable braid.
3. Hold the assembly securely (with the cable
seated in the housing) and crimp the outer sleeve in
place using the appropriate crimping tool and
crimping die.
Cable
Crimping Tool
Outer
Sleeve
Housing
Subassembly
Figure 4
4. Trim and remove excess cable braid.
2.4. Completing the Termination
1. Slide the heat-shrink tubing over the cable and
housing subassembly as shown in Figure 5.
2. Apply indirect heat to the heat-shrink tubing with
a heat gun.
3. Assembly is now complete.
Heat-Shrink
Tubing
Housing
Subassembly
Completed Assembly
Figure 5
3. REVISION SUMMARY
Revisions to this instruction sheet include:
•
Changed company name and logo
