408-2235
2 of 2
Rev C
4. Make certain that the wire barrel and braid ferrule
of the crimp end are resting firmly on the crimping
dies. See Figure 3.
5. Hold the assembly in place and close the handles
until the CERTI-CRIMP hand crimping tool ratchet
control releases to complete the crimp.
3.2. Interchangeable Dies
Series TNC COAXICON crimping dies are used in
tools 69710 and 69365. Read the instructions shipped
with the tools for information concerning die insertion
and general tool performance, then proceed as
follows:
1. Place the crimping dies in tool.
2. The die assemblies have double sets of crimping
dies similar to those in hand tools. See Figure 4.
Figure 4
3. Place the jack or plug crimp end in the crimping
dies as shown in Figure 5.
Figure 5
4. Make certain the wire barrel and braid ferrule of
the crimp end are resting firmly on the crimping
dies. See Figure 5. Hold the assembly in place and
complete the crimp.
4. JACK AND PLUG ASSEMBLY
1. Assemble the jack crimp end and jack body as
shown in Figure 6.
Figure 6
2. Assemble the plug crimp end and plug body in
the same manner as shown for the jack assembly.
See Figure 7.
Figure 7
3. Use a wrench on flats to tighten. A torque of 1.70
to 2.26 N•m [15 to 20 in.-lbs] is suggested.
5. REVISION SUMMARY
•
Updated document to corporate requirements
•
Reactivated document
Die
Holding
Screws
Stationary
Die
Moving
Die
Braid Ferrule Rests Firmly
on Ferrule Crimping Die
Wire Barrel Bottoms
in Crimping Die
Jack Crimp End
Jack Body
Crimped Ferrule
Assembled Jack
Plug Crimp End
Plug Body
Crimped Ferrule
Assembled Plug
