background image

Instruction Sheet

© 2014 TE Connectivity Ltd. family of companies
All Rights Reserved
*Trademark  

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.  Other logos, product and/or Company names may be trademarks of their respective owners. 

1

 of 4

TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.
For latest revision and Regional Customer Service, 
visit our website at 

www.te.com

LOC B

408-32033

PRO-CRIMPER* III Hand
Crimping Tool Assembly 2161732-1
with Die Assembly 2161717-1

09 JAN 14  Rev B

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use 

and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

Figure 1

1. INTRODUCTION

This instruction sheet provides application and 
maintenance procedures for PRO-CRIMPER III Hand 
Tool Assembly 2161732-1 and crimping die assembly 
2161717-1. See Figure 1. The hand tool consists of 
the die assembly and PRO-CRIMPER III Hand Tool 
Frame Assembly 354940-1 (refer to Instruction Sheet 
408-9930 for use and maintenance on the hand tool 
frame). The die assembly can be purchased 
separately, or purchased with the hand tool.

For information on connector part numbers and 
connector assembly procedures, refer to the 
appropriate instruction sheet packaged with the 
connector.

Dimensions in this instruction sheet are in metric 

units [with U.S. customary units in brackets]. 

Figures and illustrations are for reference only and 

are not drawn to scale.

Read these instructions and all referenced materials 
thoroughly before using the die and tool assembly.

2. DESCRIPTION 

(See Figure 2)

The die assembly features an anvil die and a crimper 
die. When closed, the dies produce three crimping 
chambers that crimp the ferrule of the connector. Each 
die is held in the tool jaws with a single die-retaining 
screw.

3. DIE INSTALLATION 

(Figure 2)

1. Close the tool handles until the ratchet releases; 
then allow the tool handles to open FULLY.

2. Install anvil die in the moving jaw of the hand tool. 
Align the die with the retaining screw hole; then 
secure die with the button head cap screw. Do NOT 
fully tighten.

3. Install crimper die in the stationary jaw of the 
hand tool. Slowly close the tool handles, allowing 
the die to align itself with the upper die. When dies 
are properly aligned, securely tighten both screws.

PRO-CRIMPER III 

Frame Assembly 

354940-1

The PRO-CRIMPER III Hand Crimping Tool is a “Commercial” grade tool and is designed 

primarily for field installation, repair, maintenance work, or prototyping in industrial, 

commercial, or institutional applications. Product crimped with this tool will meet the crimp 

height requirement for hand tools in the appropriate Application Specification (114-series), 

but may not comply with other feature parameters of the specification. 

TE Connectivity offers a variety of tools to satisfy your performance requirements. 

For additional information, contact the Tooling Assistance Center at 1-800-722-1111.

Crimper Die

(Stationary)

Anvil Die 

(Movable)

Crimping Die 

Assembly 

2161717-1

Die 

Retaining 

Screws

NOTE

i

O

R

IG

INAL  

INST

RUCTIONS

Отзывы: