408-32056
2
of 2
Rev
C
metal shell until the mounting holes of metal shell
align with the mounting holes of the pc board. See
Figure 2, Detail B.
6. Apply a low-strength threadlocker to each of the
customer-supplied screws. Then, thread the screws
through the mounting holes in the pc board and into
the mounting holes of the metal shell. Using a
screwdriver, tighten each screw to a torque of
.226 Nm [2 lb-in.]. See Figure 3.
7. Turn the assembly over so that the pc board is
sitting on the flat surface. See Figure 4. Fit the
backplate (with the countersinks facing outward)
over the back of the header module, and thread the
attachment screws into the screw holes of the
backplate. Tighten each screw to a torque of
.226 Nm [2 lb-in.].
4. DISASSEMBLY
The backplate and metal shell can be removed from
the header modules and pc board by removing the
attachment screws, then the customer-supplied screws.
5. REPLACEMENT AND REPAIR
Do not use defective or damaged components.
All components of the module assembly kit can be
re-used after disassembly.
6. REVISION SUMMARY
Revisions to this instruction sheet include:
•
Corrected torque value in Steps 6 and 7
Figure 3
Figure 4
Customer-Supplied
Screws Tightened
Securing Metal Shell to PC Board
Customer-Supplied
M2x0.4 Screw
Threaded into
PC Board
Mounting Hole
Installing Backplate onto Metal Shell
Backplate
Attachment
Screw
(2 Places,
Shown Not
Secured)
Back of
Metal Shell
Countersink of
Screw Holes
Facing Outward
