TE Connectivity FDH 3000 864, Руководство пользователя

Страница: 34 / 56

ADCP-96-088 • Issue 2 • 6/2013
Page 28
© 2013, Tyco Electronics Corporation. All Rights Reserved.
4. Remove the cable entry/exit hole cover and attached flexible membrane from the bottom
of the cabinet.
5. Locate the cable clamping position specified for the next distribution cable as shown in
Figure 22 .
Figure 22. Secure Distribution Cable to Cabinet Center Partition
6. Remove the two cable clamp assemblies that correspond to the selected cable clamping
position from the cabinet center partition.
7. Feed the distribution cable through the specified cable entry/exit hole and into the cable
duct or mounting sleeve that is located beneath the cabinet. Pull all excess slack out of the
cable.
Note: Figure 21 shows how to remove the entry/exit hole cover for distribution cables 1–6.
The entry/exit hole cover for distribution cables 7–12 is mounted on the opposite side of
the cabinet center partition and may be removed using the same basic procedure.
PANEL 7
CABLE POS 8
PANEL 8
CABLE POS 9
PANEL 12
CABLE POS 1 3
PANELS 7 - 12
REAR LEFT SIDE
21635-D
PANEL 1
CABLE POS 1
PANEL 3
CABLE POS 3
PANEL 9
CABLE POS 10
FEEDER 1
CABLE POS 7
FEEDER 2
CABLE POS 14
PANEL 4
CABLE POS 4
PANEL 10
CABLE POS 11
PANEL 6
CABLE POS 6
PANEL 5
CABLE POS 5
PANEL 11
CABLE POS 12
PANEL 2
CABLE POS 2
PANELS 1 - 6
REAR RIGHT SIDE
1
2
3
4
5
6
7
8
9
10
11
12
13
14