412-10100
Rev A
17
of 74
3.3
System settings
Touch the system settings icon to display the System Settings screen (Figure 6). This screen is used to set up
the basic system configuration.
Figure 6: System settings
NOTE
The System Settings must be configured
by the CQM administrator
before any CQM settings are modified. Production
cannot be run until configuration of the System Settings is complete.
NOTE
All other machine options must be installed before the System Settings are configured. Do not be confused with the CQM
Installed option. In most configurations this should be selected as installed. Only the AMP 3K/5K (with stripper module
installed) can be used without the CQM installed.
3.4
CQM settings
CQM Settings refers to the initial setup of the CQM II before production begins. This setup is performed by the
CQM administrator. For system setup information, refer to section 6.
To access the CQM settings, touch the CQM Settings icon on the control panel screen (Figure 7).
Figure 7: CQM settings icon
