409-5861
16 of 26
Rev B
198
22
B:
Figure 11
Operating Modes on Operator Control Panel
FULL CYCLE
When the manual cycle button is pressed in this mode, or a cycle signal is received from the
parent machine, the crankshaft will rotate at full speed through a full revolution.
FUNCTION
BUTTONS
Function
Total Cycle
Counter
Mode Icons
Lights
Batch Counter
16-Character
Display
Function
Buttons
SPLIT CYCLE
When the manual cycle button is pressed in this mode, or a cycle signal is received from the
parent machine, the ram will move partially down to capture the terminal in the tooling (without
crimping it). After the wire is inserted into the terminal, the manual cycle button must be pressed
again or a cycle signal is necessary to complete the cycle (crimping the wire to the terminal) and
return the ram to the “fully retracted" position.
JOG MODE (Forward)
When the manual cycle button is pressed in this mode, the crankshaft moves in the forward
direction at a reduced speed. The motor is activated only while the manual cycle button is
pressed and held. Power to the motor is removed immediately when the manual cycle button is
released. The motor automatically stops when the ram is returned to the “fully retracted" position.
NOTE:
The ram may drift down if the manual cycle button is released in mid stroke.
CAUTION: While in JOG mode, attempting to complete a crimp cycle with terminals and wire
in the applicator may cause the motor to stall. Although the terminating machine can
terminate some smaller terminals and wire, the motor may be unable to complete
the cycle. It may be necessary to either reverse or turn OFF the machine and
manually return the ram to the “fully retracted" position.
JOG MODE (Reverse)
This mode allows a slow speed jog in the reverse direction. Operation is similar to the
JOG mode (Forward).
