background image

408-8569

2 of 4

Rev A

Figure 2

3. INSTALLATION AND SETUP OF

CONNECTOR -SPECIFIC KIT

3.1. Installation

These procedures are typical for the manual arbor 
frame assembly and the pneumatic auto-cycle unit.

1. Loosen the two socket head cap screws that 
secure the locators onto the lower insert.

2. Place the connector between the locators and 
slide the locators against the connector; then 
secure the locators by fully tightening the socket 
head cap screws.

Depending on which style connector is being 

terminated the connector will rest on either the 

mating face of the connector on the bottom of the 

slot that is in the lower insert; or the shoulders of 

the connectors will rest on the step of the lower 

insert, as shown in Figure 3.

When locating the connector in the lower insert be 

sure to center the connector as much as possible.

3. When the locators are secure, remove the 
connector from the lower insert.

4. Remove the screw that secures the adjustment 
block to the universal arbor tool then remove the 
adjustment block. Slide the lower insert onto the 
base assembly until it is against the compression 
spring. See Figure 2.

5. Re-assemble the adjustment block. Make sure to 
orient the block so that the fine adjustment screw is 
closest to the right side and bottom side of the 
block. See detail in Figure 2.

To avoid improper terminations, the adjustment 

block must be re-assembled properly.

6. Loosen the fine adjustment screw so that it is not 
touching the lower insert.

7. Install the Base Assembly Universal Arbor Tool 
onto the frame assembly, as described in 408-4201.

To avoid personal injury, be sure to disconnect the 

air from the main air valve when using Pneumatic 

Auto-Cycle Unit 91112-3.

3.2. Setup

1. Remove the cover from the connector and place 
the connector into the lower insert as described in 
Paragraph 3.1.

Universal Arbor 

Tool (Ref)

Compression 

Spring

Socket Head 

Cap Screws

Arbor Frame 

Assembly (Ref)

Adjustment 

Block

Screw

Detail

Fine Adjustment 

Screw

NOTE: Guards not shown for clarity.

(See Detail)

Locators

Lower 

Insert

NOTE

i

!

CAUTION

!

CAUTION

DANGER

STOP

Отзывы: