409-32023
Rev
B
18 of 41
e. When the precision controller is connected to a Komax leadmaker, the IP address will need to be
set. Click down
until “Automatic Address” is highlighted as shown in Figure 22. Then click the
Check button. This will uncheck the box with the X. The screen will change to show an IP address
of 169.254.1.1 as shown in Figure 22. This may take some time.
NOTE
If there is more than one precision controller in the system, each unit must have a unique IP address. It is recommended that
that station 1 have an IP address of 169.254.1.1 and station 2 have an IP address of 169.254.1.2.
To change the IP address, click the Up button until the last digit of the IP address is highlighted.
Click the Check button to enable the setting of the last digit of the IP address. See Figure 24.
Use the up/down arrows to set the last digit to the desired number. Refer to Figure 24. Then click
the Check button again to accept the new IP address.
The IP address can be set from 1 to 9.
NOTE
It is important to power off the machine after the IP address on the precision controller is changed. This will allow the software
to obtain the correct IP address when the machine is powered up.
Figure 24
Viewing the Smart Applicator Data
1. To view the smart applicator data, select the terminator in the TopWin software Setup screen. See
Figure 25
Downloaded From
