408-10215
Rev
C
2
of 8
1.
INTRODUCTION
SDE Crimp Commercial Hand Tool Assembly 2031973-1 is the tool and die set shown in Figure 1. The tool
consists of the SDE Crimp Frame Assembly 2362810-1 (instruction sheet
) and the die assembly
listed in Figure 1. This tool is used to crimp the terminal part numbers listed in Table 1.
Table 1: Crimping specifications
Die assembly
Part number
Wire size mm
2
Insulation
1.5-2.0
0.5-1.0
0.5-0.8
0.2-0.35
Size
Strip length
2031973-2
926895-[ ]
1.0-2.5
4.3
926896-[ ]
926897-[ ]
926893-[ ]
2.0-3.3
926894-[ ]
926898-[ ]
NOTE
Dimensions in this instruction sheet are in millimeters with [inches in brackets]. Figures are for reference only and are not
drawn to scale.
Read these instructions thoroughly before crimping connectors.
2.
DESCRIPTION
The tool frame features two jaws, a handle, a ratchet adjustment wheel, and an emergency ratchet release.
Each die set consists of a crimper (upper die) and an anvil (lower die). The tool frame holds a die assembly
with four crimping chambers (see Figure 1). Die-retaining screws and spring pins are used to secure the dies in
the tool frame.
The tool features a ratchet and an adjustment wheel with a range of settings. The ratchet ensures that the tool
has completed the cycle and does not release until the handles have
fully
closed, unless the emergency
ratchet release is rotated to manually release the ratchet. The adjustment wheel controls the amount of handle
pressure exerted on the dies during the crimping procedure.
CAUTION
The dies bottom before the ratchet releases. This feature ensures maximum tensile performance of the crimp.
Do not
re-
adjust the ratchet unless you have verified that the crimp height is incorrect (see section 8, ADJUSTING THE RATCHET).
