408-4847
2 of 2
Rev B
4. Thread the jack into the connector housing by
turning the handle of the torque tool clockwise until
the handle releases. See Figure 5, Detail A.
5. While holding the collet of the torque tool with the
open wrench, turn the handle counter- clockwise,
and remove the jack assembly from the torque tool.
See Figure 5, Detail B.
6. Install the jack assembly onto the panel.
Connector Housing
Handle of Torque Tool
Collet (Ref)
Turn Handle Clockwise
Turn Handle Counterclockwise
Detail A
Detail B
Figure 5
4. REPLACEMENT AND REPAIR
Discard and replace any defective or damaged jack
receptacles or metal gaskets.
5. REVISION SUMMARY
Since the previous version of this document, the
following changes were made:
•
Updated document to corporate requirements.