AN-000327
Page 4 of 11
Document Number: AN-000327
Revision: 1.0
GETTING STARTED
SmartSound One uses a micro USB connection to supply power and output audio data. Up to two (of the same audio interface type)
TDK FPCB microphones can be connected to the ZIF connectors (shown in
Figure 2
) to measure the audio output in any audio
recording software. Before using the board, it is recommended to first follow the instructions in this section to ensure the setup is
correct.
Figure 2.
Microphones connected to SmartSound One Module
Figure 3.
Edge connector FPCB (Top side)
Figure 4.
Edge connector FPCB (Bottom side)
