TDK-Lambda RWS 1000B Series, Инструкция по эксплуатации

Страница: 5 / 19

INSTRUCTION MANUAL
RWS1000B
•
1500B Series
TDK­Lambda
<Page>
/FO, /RFO
CN83, CN84 : Remote sensing, PF signal, Parallel operation setup
Remote ON/OFF control (Only /RFO)
* CN83, CN84 Connector (JST)
Each other terminals are same as standard model.
"+Vm" terminal (Pin No.1) to "+S" terminal (Pin No.2), and "­Vm" terminal (Pin No.9) to "­S" terminal
(Pin No.10) are connected by short pieces (connected to CN83) at time of shipment.
/R
CN83, CN84 : Remote ON/OFF control
* CN83, CN84 Connector (JST)
Each other terminals are same as standard model.
"+Vm" terminal (Pin No.1) to "+S" terminal (Pin No.2), and "­Vm" terminal (Pin No.9) to "­S" terminal
(Pin No.10) are connected by short pieces (connected to CN83) at time of shipment.
5/19
10
9
7
5
3
1
8
6
4
2
10
CN83,CN84
10
No. Configuration Function
1 +Vm
Output monitor terminal (+V). Internally connected to +Output terminal.
(+Vm terminal can not supply load current.)
2 +S
Remote sensing terminal for +output.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to +Vm terminal when
remote sensing function unnecessary.)
3 +R
Remote ON/OFF control terminal (Only /RFO). Do not connect for /FO. If
connected may cause malfunction.
4 ­R
GND for Remote ON/OFF control terminal (Only /RFO). Do not connect
for /FO. If connected may cause malfunction.
5 +PF
Power fail signal (PF signal) output terminal.
(Open collector output. As the output voltage drops or FAN stop and AC
input voltage down, "PF" signal will be "High".)
6 ­PF GND for PF signal.
7 COM Current barance terminal. (For current balancing in parallel operation.)
8 PC Current barance terminal. (For current balancing in parallel operation.)
9 ­Vm
GND for Output monitor terminal. Internally connected to ­Output
terminal.
( ­Vm terminal can not supply load current.)
10 ­S
Remote sensing terminal for ­output side.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to ­Vm terminal when
remote sensing function unnecessary.)
No. Configuration Function
1 +Vm
Output monitor terminal (+V). Internally connected to +Output terminal.
(+Vm terminal can not supply load current.)
2 +S
Remote sensing terminal for +output.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to +Vm terminal when
remote sensing function unnecessary.)
3 +R Remote ON/OFF control terminal.
4 ­R GND for Remote ON/OFF control terminal.
5 NC No cnnection
6 NC No cnnection
7 NC Do not connect. If connected may cause malfunction.
8 NC No cnnection
9 ­Vm
GND for Output monitor terminal. Internally connected to ­Output
terminal. ( ­Vm terminal can not supply load current.)
10 ­S
Remote sensing terminal for ­output side.
(For remote sensing function, which compensates for line drop between
power supply terminals and load terminals. Connect to ­Vm terminal when
remote sensing function unnecessary.)
9
7
5
3
1
8
6
4
2
10
CN83,CN84