TDI T
URBO
T
WIN
FROM
TECH DEVELOPMENT
Publication T30-906
Page 1
Issued January 8, 2016
1.0 GENERAL INFORMATION
This manual provides instructions for the
installation and operation of the TDI
TurboTwin™ Model T30 ML air motors. If
there are questions not answered by this
manual, please contact your TDI
TurboTwin™ distributor or dealer for
assistance.
The T30 ML is a turbine driven air motor
with a .625” diameter keyed output shaft.
The T30 ML is designed for installation on
an oil pump with D-type mounting flange.
The T30 Series motors are suited to operate
within a wide range of inlet air pressures and
ambient temperatures.
A pressure regulator installed within 10 feet
of the motor can be used to adjust pressure
to the motor.
The T30 Series motors are designed for
operation with compressed air or natural
gas. Moderate amounts of foreign matter or
liquid in the air stream will normally not
adversely affect T30 Series motors.
As with all other TDI TurboTwin™ models,
no lubrication
is required in the supply air.
You need to review the rest of this manual
before installing your TDI TurboTwin™ T30
Series motor.
1.1
WARNINGS, CAUTIONS, & NOTES
Throughout this manual, certain types of
information will be highlighted for your
attention:
WARNING
- used where injury to
personnel or damage to the
equipment is possible.
CAUTION
- used where there is the
possibility of damage to the
equipment.
NOTE
- used to point out special
interest information.
1.2 INSTALLATION and SERVICE
The TDI TurboTwin™ T30 Series motors
provide distinct advantages of size and
efficiency compared to electric motors,
vane-type, or other turbine-type air motors.
It is important to properly install the motor to
receive full benefit of these advantages.
Repair technicians or service organizations
without turbine motor experience should not
attempt to repair this machine until they
receive factory approved training from TDI,
or its representatives.
Proper operation of your TDI TurboTwin™
T30 Series motor will assure continued
reliable and superior performance for many
years.
WARNING
The TDI TurboTwin™ T30 Series motors
must be installed and operated in
accordance with the instructions given in
this manual. Failure to properly install the
motor or failure to operate it according to
these instructions may result in damage to
the motor, the engine, or cause personal
injury.
NOTE
THIS MOTOR IS TO BE SERVICED ONLY BY
AUTHORIZED TDI TURBOTWIN™ DISTRIBUTORS,
DEALERS, AND REPAIR STATIONS. DO NOT
OPERATE THIS MOTOR UNLESS IT IS PROPERLY
INSTALLED ON AN ENGINE.
2.0 ORIENTATION OF THE
MOTOR
The factory orientation of the motor’s
mounting flange is ideally configured for
most applications and does not required
reorientation.
2.1 MODEL T30-I
ORIENTATION
Determine the required orientation of the
optional exhaust port if installed.
