TCS QD3041, Руководство по установке

Страница: 13 / 25

2800 Laura Lane • Middleton, WI 53562 | 800.288.9383 | www.tcsbasys.com
13 13
Configuration
Controller View
This section allows you to see what controllers have been found by the QD3041. It also shows addressing and Device ID
information, vendor information and communication status. This information allows the installer to verify that each con-
troller has been found by the QD3041 and is communicating with the local network. Clicking the green Refresh button on
the Controller View title bar will refresh each controller’s status.
System Commands
This section describes how to set up system flags for the QD3041. “Reboot Unit” sets a flag which will reboot the QD3041
within a five-minute cycle. “Restart Application” will restart the software running on the device. “Check for Update” con -
tacts the Ubiquity Cloud Server for any updates relevant to its particular model number and software version. When an
update has been downloaded, it is automatically applied; the unit will reboot if necessary.
NOTE: The “Check for Update” command requires that the QD3041 have Internet access to retrieve the update patch.
QD3041 Configuration via Command Line Interface (CLI)
When you connect a keyboard and monitor to the QD3041 (See “Appendix C: Monitor and Keyboard” on page 25 ), you
can configure it for your site by using the built-in CLI.
1. To establish a connection to the CLI, you must enter a login user name and password. If you have not changed the
user name and password, you must enter the default credentials.
NOTE: If you do not have the default credentials for this unit, contact TCS Technical Support at 800-288-9383 ext. 2 for
assistance.)
2. Once logged in, type in “tcssetup.” This will open the CLI (see “Command Line Interface Screens” on page 14 ).
3. Type the number for the selection you want and press “Enter”.
4. Type in new values on any field as needed. Pressing “Enter” will save the new value, or keep the current value.
5. When finished with a section, type “0” and press “Enter” to go back to the main menu.
6. After all programming is complete, navigate back to the main menu and type “8” and then press “Enter.” This will
save all changes. Typing “0” and pressing “Enter” at the main menu will exit programming without saving changes.
NOTE: After you have finished configuring the QD3041, you can revert your laptop back to its original DHCP settings, if
desired. See “Appendix B: Revert Back to DHCP Settings” on page 22.