PI_GB_PES_PDS_Art0015689_1v0.doc 7
10/2005
Assembly
1. Opening the case
The lower panel is attached to the aluminium
profile by two hexagon socket screws.
(1)
Unscrew both screws using an Allen key
only half way:
(2)
Turn the lower panel to the left, without
removing it completely.
(3)
Slide the name plate glass fully down.
2.
Feed the cables through the cable duct.
3.
Attach the device safely to the wall from the
attachment holes (see overview) using suit-
able screws.
Take care not to pinch the cables under the
spacers on the device back.
4. Closing the housing
Slide the name plate glass upwards under
the front panel.
Turn the lower panel to the right until the re-
cess fits over the screw.
Tighten the screws.
!
When sliding the name plate glass upwards take care not to damage the rubber seals
in the guide grooves.
When fitting additional devices make sure that you can slide
the name plate glass of the device downwards out of the profile. Do not fit a device
below the device.
!
Never seal the device using silicon! Condensate must be allowed to drain and evapo-
rate.
TCS TürControlSysteme AG
•
Geschwister-Scholl-Str. 7
•
39307 Genthin
Subject to change without notice.
Phone: +49 39 33 / 87 99 10
•
Fax: +49 39 33 / 87 99 11
•
www.tcs-germany.com
Art.Nr. 0015689 Version 1.0 mi
