8
Connect the lines
Minimise the length of the lines above
the lower cover to place the lines with-
out any problems and to prevent
clamping the lines when snapping-on
the upper cover.
Connect the lines according to the
labeling within the lower cover to the
connection terminal. (The terminal can
be removed from the guide rail.)
Run the lines along the dedicated site.
Ensure that there is no uninsulated or
not connected wire (e.g. cable shield)
in the space for cabling as this could
cause a short-circuit.
a
b
E
P
M
C V1
V
2
Set indoor station as end device
The indoor station is positioned at the
end of a strand or is the only device in
the strand:
Push the slide switch S1 (on the print-
ed circuit board in the upper cover) to
the right. Thus, the matching resistor is
“placed“.
(s
cope of delivery: “not placed“)
Snap-on the upper cover
Set the upper cover on both latches of
the lower cover (
1
).
Snap-in the upper cover with slight
pressure (
2
).
S1
