02
Warnings and Precautions
Do not touch the screen surface with fingers as this may scratch the LCD screen. Also it is hard to clear the skin grease
left on the screen.
Do not impact the LCD screen with hard pressure as the LCD screen is very delicate and fragile.
Read all of the instructions before operating the set. Keep these instructions well for later use.
All instructions must be followed during the operation.
PRODUCT
Do not cover or block the ventilation openings on the back cover.
Unplug the set when it is not used for a long period of time.
Do not use the sharp objects, the metal or the liquid to touch the signal plugs or push the object of this kind into the
ventilation slots as it may cause short circuit and damage the unit.
Do not dismantle or disassemble any parts of this product by yourself as this may damage the product, cause personal
injuries and violate the warranty of your products.
PO
W
ER
Unplug the set under the following conditions:
PO
W
ER
CORD
&
S
I
GNAL
CA
B
LE
Do not allow anything to rest on the power cord or signal cable.
Do not overload the power cord or power outlet.
To prevent the power cord or signal cable from being trampled, do not make them through the walkway, or the place
where people often walk.
.
Do not expose the power cord or signal cable to moisture.
USE
EN
VI
RON
M
ENT
Never place the set, remote control or
batteries near naked flames or other heat
sources, including direct sunlight.
To prevent the spread of fire, keep candles
or other flames away from the set, remote
control and batteries at all times.
Apparatus shall not be exposed to dripping
or splashing and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
Do not put the set near the heavy dust place.
Do not put the set near the too hot, cold or
damp place.
Do not place the set on an unstable cart,
stand, or table.
Put the set on a place that allows good
ventilation.
CLEAN
I
NG
Do not apply excessive force to the screen when cleaning.
Do not use water or other chemical cleaner to clean the screen as this may damage the surface of the LCD screen.
Note
: The unit is applied to industry, not fit for domestic use.
When cleaning the LCD screen, please use a dry, soft and hairy cloth or use the specific cleaner for liquid crystal to
clear the dust and the smudge.
Please use the 2-pin plug.
PLUG
If the set will not be used for a long period of time;
If the power cord or the power outlet/plug is damaged;
If the set is subject to impact or has been dropped to have the cabinet damaged.
Following the instructions to install and adjust the product. Do not adjust or operate the unit by the method or programes
not covered in this operation manual. Once you insist on doing so and unexpected circumstance happens, unplug the
set and call the service/technical personnel for an assistance;
Note
: Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.