TTECorporation R&D Center (Shen’Zhen Lab)
Chassis Name
M28
SP
(G8)
Serial No.
Issued on
2006-06-02
Updated on
2007-3-21
Version
3.1
4.
Repeat step 2&3 until you can get the correct reading for both black and white sides.
5.
DVD White Balance fine adjustment Item: UBK, VBK. (11500 K) (Press key 0 in D-Mode)
6.
Setting in Original EEPROM, Warm: x=291, y=300(8500 K); Adjustment Item: WRCUT, WGCUT, WBCUT,
WGDRV, WBDRV.
7.
Setting in Original EEPROM, Cool: x=265, y=265(15000 K); Adjustment Item: CRCUT, CGCUT, CBCUT,
CGDRV, CBDRV.
VI) Adjustment of Pincushion and Picture Width (for pure flat model only)
1.
Receive a crosshatch pattern.
2.
Adjust VR1124 until the vertical line become straight.
3.
Adjust VR1123 for horizontal size.
4.
Enter D-Mode, press KEY FM to select HBP, adjust for Horizontal BOW and Horizontal Parallelogram.
VII) Adjustment of Picture Geometry (PAL) <Press KEY 1 IN D-Mode>
1.
Apply the crosshatch pattern (PAL signal) to the RF input, in STANDARD status.
2.
Select HPOS to adjust the Horizontal center.
3.
Select VP50 to adjust the Vertical center.( If Vertical output is DC Coupling, pls. adjust VCENP)
4.
Select HIT to adjust the Vertical amplitude.
5.
Select VLIN to adjust the vertical linearity.
6.
Select VSC to adjust the vertical S-correction.
XIII) Adjustment of Picture Geometry (NTSC) <Press KEY 1 IN D-Mode>
1.
Apply the crosshatch pattern (NTSC signal) to the RF input, in STANDARD status.
2.
Select HPS to adjust the Horizontal center.
3.
Select VP60 to adjust the Vertical center.( If Vertical output is DC Coupling, pls. adjust VCENN)
4.
Select HITS to adjust the Vertical amplitude.
5.
Select VLIS to adjust the vertical linearity.
6.
Select VSS to adjust the vertical S-correction.
IX) Adjustment of OSD position
1.
Enter D-mode and press key “1”, then choose OSDH(OSDHS) item and adjust the OSD vertical
position 50HZ(60HZ).
2.
Enter D-mode and press key “NOTEBOOK”, then choose the OSD1 item and adjust the OSD
horizontal position(Volume bar, Picture bar, Half blue panel OSD).
3.
Enter D-mode and press key “NOTEBOOK”, then choose the OSD2 item and adjust the OSD
horizontal position except OSD1 item.
X) LOGO setting
1. Enter D-mode and press key “6”, then choose FLG1 item and adjust.
9