Factory Test & Alignment Specification For RT95-AP Series (V1.0)
15
then click the
Start
item and then power on the TV. You’ll see the burning of Mboot.
How to upgrade FLASH SW
There are two methods to upgrade SW,
one way like below
：
Download the bin file “install.img” to the root directory of
your USB device, and do not change the file name. Then
insert the USB device to USB interface of TV set.
Power on the TV set, Press and hold on the power key of
key board at the same time. If the TV is updating, you’ll
see the below screen:
After updating, the TV set will reset automatically.
Note:
If there’s already other “install.img” in USB root, it
should be deleted or renamed.
The other way
：
Download the bin zip file “install.img” to the root directory of your USB device. and do not change the
file name. Then insert the USB device to USB interface of TV set.
Press RCU
Menu/TV Setting/Picture/Professional Setting/Contrast/1,9,5,0/Service menu/USB
Update /Main Upgrade/Local Update
. If the upgrade file is found, TV will give a message that it
verifying. TV displays a warning message, it means selecting “confirm” to continue or “cancel” to exit.
During updating, do not power off the TV set.
After updating, the TV set will reset automatically.
Appendix 3: Network Connection
You can set up your TV so that it can access the Internet through your local area network (LAN) using a
wired or wireless connection.
Connecting to a wired network
Attach the TV set to your LAN using cable in three ways:
Connecting the LAN port on the TV to an external modem using a Cat 5 cable.
Connecting the LAN port on the TV to an IP Sharer which is connected to an external modem. Use
Cat 5 cable for the connection.
Depending on how your network is configured, you may be able to attach the TV to your LAN by
connecting the LAN port on your TV directly to a network wall outlet using a Cat 5 cable. Note that the
wall outlet is attached to a modem or router elsewhere in your house.
Select
Home-> Settings-> Network Settings-> Wired Settings
, then select “
Auto Get IP Address
” or
“
Manual Set IP Address
” to connect to a wired network.
Connecting to a wireless network
To connect the TV set to your network wirelessly, you need a wireless router or modem and a Wireless
LAN Adapter.
If the TV set is equiped with a internal WIFI, select
Home-> Settings-> Network Settings-> Wireless
Settings
, then turn on
Wireless Switch
, select a wireless network and press
OK
to connect.
If you want to connect the TV set to a wireless network by a Wireless High Gain USB Adapter (USB
dongle), select
Home-> Settings-> Network Settings-> Wireless Settings
, then turn on
Wireless
