TCL C1208DRW, Руководство пользователя, Страница: 9 / 24

II. Dryer Installation
• All packaging materials should be removed from the dryer. Make sure no items are
• The dryer shall not be placed in a dusty place to prevent the accumulated dust from
blocking the air duct of the dryer.
placed on the top.
• The dryer should be placed on a solid flat surface.
• During installation, use the leveling feet to make sure the dryer is level and stable. Do not
use plush carpet, wooden strips or similar to fill the gaps between its feet andthe floor, so
as to prevent interference with its operation.
• At least 5 cm shall be kept between the dryer and any furniture or walls.
1. Adjust the leveling feet to level the dryer.
2. Connect to the power supply.
Before powering on, check:
1) Whether the power voltage meets the requirements;
2) Whether the power socket matches the plug of the dryer;
3) Whether the power socket can withstand the maximum power of the dryer and wheth-
er the socket is reliably grounded;
3. Drain pipe installation
There are two ways in which you can handle the drainage of condensate. As default,
the condensate will accumulate in the water tank, and will need to be emptied after
each cycle. Alternatively, if the dryer is within reach of a draining outlet, follow the
steps below to connect your dryer to your draining outlet:
1) Disconnect the drain hose
and connector attached to
the back of the dryer.
2) Connect the external drain
hose to the removed drain
hose plastic connector.
be firmly connected;
Notes:
1) Water hose connections shall
2) After connection, the height of
the drain hose should not
exceed 1m above the ground;
3) The external drain hose may
be shortened if it is too long.
4) If you need to remove the
external drain hose, make
sure you disconnect at the
plastic connector. Then, make
sure that you re-connect the
plastic connector to the short
tube off the water tank to
prevent any water leakage.
7
Drain hose
Short tube off the water tank
Plastic connector