TCL 4A-LD50O5-CMJGTA, Руководство по обслуживанию

Страница: 14 / 36

Factory Test & Alignment Specification For MS08PA-LA Series (V1.0).Doc
Page 7 of 18
The status of “ Factory Key ” can be changed in Factory Menu -> Hotkey.
Press RCU “ OK ” key or “ RIGHT ” key to enter the submenu.
Press RCU “ Menu ” key to go back to the root menu.
Press RCU “ RIGHT ” or “ LEFT ” key to change the values.
Press RCU “ OK ” key run the function.
Press RCU “ Exit ” key exit the Factory menu.

Factory Captions Info.
While “ Factory Key ” is enabled, there’re some toggled display information relative to SW, Project
ID, ADC Status, to facilitate 100% quick screening without accessing to whatever else menu:
P (Production/Factory mode flag)
Project ID
Main SW Version
Mboot SW Version
See Appendix

“ Factory Menu Description ”
2.2. Warm-up Test
Following TCL standard and practices, it’s required minimum 15min of Warm-Up that can be
considered as Burn-In.
Additional Aging for White Balance alignment is no more necessary due to consistent Picture
Performance with Cloning usage.
This function is accessible by selecting “ Factory menu

WARM-UP ”, pressing RCU “ Zoom+ ”
key and then leaving Factory menu. Other faster methods are available on above enclosed
SIACP requirements (rev. v3.9).
2.3. White Balance (WB)

As some color coordinates discrepancies can be noticed from panel batches to others, it may
necessary to perform slight touch-up.
White Balance Touch-Up
For Color temperature adjustment, switch TV on leading HDMI input where should be connected
suitable generator providing following format 1280x720p@60Hz test pattern. A 32 steps grey scale is
recommended to assess relevant colorimetry tracking and low/high light saturation points.