TCi HarmonicGuard Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 30

2 HGL IOM Manual - Rev. B
HarmonicGuard
®
Low Capacitance
Introduction
General Safety Instructions
These safety instructions are intended for all work on the HGL. Additional safety instructions are
provided at appropriate points on other sections of this manual.
Warning
!
Be sure to read, understand, and follow all safety instructions.
Warning
!
Only qualified electricians should carry out all electrical
installation and maintenance work on the HGL filter.
Warning
!
All wiring must be in accordance with the National Electrical
Code (NEC) and/or any other codes that apply to the
installation site.
Warning
Disconnect all power before working on the equipment.
Do not attempt any work on a powered HGL filter.
Warning
The HGL filter, drive, motor, and other connected equipment
must be properly grounded.
Warning
After switching off the power, always allow 5 minutes for the
capacitors in the HGL filter and in the drive to discharge before
working on the HGL, the drive, the motor, or the connecting
wiring. It is a good idea to check with a voltmeter to make sure
that all sources of power have been disconnected and that all
capacitors have discharged before beginning work.