Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Giessen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Page 19 of 28
!
3.4 Mounting
Please ensure professional mounting by authorized personal.
Furthermore the system must be separated from the electricity supply and
therefore be electrically discharged.
Follow these points for mounting:
1. After unpacking the unit place it with the surface on the inner part of the packaging.
Therefore you can protect the chassis against damaging!
2. Make the mounting hole and drillings in accordance with the data in chapter „technical
drawing“.
3. Insert the system flush-mounted into your mounting hole. Make sure that the seals are
properly mounted, otherwise the indicated safety class cannot be achieved.
Tighten now with suitable nuts evenly and crosswise.
A24-iTFT:
Max.: Torque 1.1 Nm with aluminum front
Max.: Torque 2.3 Nm with stainless steel fronts
You can recognize the optimal position by the fact that the seal on the rear side, which is
inserted into the front, is no longer visible. If you screw longer, there is the risk that the
permissible max. torque is exceeded and the pin and the front can be damaged.