• 22 •
Cup for Filter coffee
or Cappuccino
: dispensing spout raised and tray in
the outer position.
Glass for Frothed milk : dispensing spout
raised and tray in the inner position.
Espresso
(white) = "black capsule"
Caffè crema
(yellow) = ''yellow capsule''
Filter coffee
(blue) = "blue capsule"
Cappuccino
(white) = "black capsule"
Frothed milk
(white) = no capsule
BreWinG cOffee
coffee preparation
Before brewing a coffee, check that the On/Off button
and beverage buttons are constantly lit and that
there is enough water in the tank.
never insert fingers or any other objects into the
capsule compartment. single-dose capsules brew a
single coffee. dO nOT use capsules more than once. When
preparing an espresso coffee or Caffè crema, the machine
performs a prebrewing cycle, during which a small amount
of coffee may be dispensed.
We recommend emptying the used capsule tray
every day. Before inserting a capsule, make sure that
the used capsule drawer is not full.
Tip to get the best espresso from your Cafissimo Latte:
If the machine has not been used for a while and/or
the cup is cold, we suggest to place the cup below the spout
and press the espresso button, without inserting any capsule.
This will warm up the cup and the machine. Then empty the
cup and proceed with the instructions from point 1 below.
Fig.1
Fig.2
Fig.3
1-
Place a small cup, large cup or glass underneath the coffee
dispensing spout as indicated in paragraph “Dispensing height
adjustment”.
2-
Lift the capsule compartment opening lever
(Fig.1)
.
3-
Insert the capsule
as shown
in the figure
(Fig.2)
.
4-
Lower the lever to close the capsule compartment
(Fig.3)
.
If the compartment does not close easily, check that
the capsule is correctly inserted and that the used
capsule drawer is not full.
5-
Press the
(white) button for an Espresso, the
(yellow)
button for a Caffè crema or the
(blue) button for a Filter
coffee.
6-
Coffee brewing stops automatically when the set level is
reached. However, it is possible to stop the dispensing pro-
cess early by pressing the same button as the beverage being
dispensed.
7-
Lift the lever to eject the used capsule into the used capsule
drawer.
8-
Remove the cup, mug or glass from the grill.
With every coffee brewing a small amount of rest
water runs into the dip tray. Therefore, empty the
dip tray regularly.
If the dispensing of the beverage stops due to lack of
water in the tank, proceed as follows: fill the tank
with water and push the button of the drink that was being
dispensed. as soon as the desired quantity has been reached,
stop dispensing by pressing the beverage button again.
adjusting the coffee quantity
Each capsule is portioned for one cup of filter coffee, caffè crema or
espresso and optimally adjusted as regards flavour.
The machine allows you to adjust the amount of brewed coffee
according to your taste and the size of your cup/mug/glass.
Each time the Espresso
, Caffè crema
or Filter coffee
buttons are pressed, the machine brews a preset amount of coffee.
