TMN-5000i-V1
TMN-5000i Hardware User Manual (Ver.1)
9
Repeat the above same method to connect for your output device.
6.4
Step 4: Install Antenna
Locate a gold-coloured female antenna socket and plug it with the antenna provided.
6.5
Step 5: Connect Programming Cable to PC
Before you can deploy your TMN-5000i, you will need to configure it on TMAS PC
Manager via serial programming. Connect one end the programming cable (RJ12 male)
to the RS232 interface on the TMN-5000i. Please refer to Appendix A to locate the RS232
interface. Then, connect the other end of the programming cable (DB9 female) to your PC
or laptop.
6.6
Step 6: Configure TMN-5000i on PC
Connect the AC/DC power adapter to the power jack. Then, switch on the power adapter.
Check for connection to the 3G network. When the network LED blinks once in every 4
seconds, this indicates that your TMN-5000i has logged into the network.
Run the TMAS PC Manager software on your PC to configure your TMN-5000i. For more
information on configuration using the PC Manager Software, please refer to the attached
TMAS PC Manager Quick User Guide, or download the user guide from our website
product page. Once this is done, your TMN-5000i can be operated without PC
connection.
Note: You only have to configure your TMN-5000i via serial programming for the first time.
Any subsequent changes in the I/O function properties can be done again by using the
serial programming method or using wireless method. Wireless method will require a
TMAS modem T61-EHS5 to enable your PC or laptop to send SMS to configure your
TMN-5000i remotely.
