TC-Helicon Voicesolo FX150, Справочное руководство

Страница: 35 / 40

Controls – aka “Pushing buttons”
VoiceSolo FX150 Reference manual 33
EQ
+ + + =
Monitor Mix
+ Aux
1 2 Aux
EQ
REVERB
Edit
VOICE SOLO FX-300
Master
Level Level Level
High
Mid
Low
High
Mid
Low
High
Mid
Low
Level Style Level
Voice
Cancel
Vocal
Tone
Vocal
Tone
HI Z
FULL MIX
Master
Edit
– Press the “High” button and use the Edit knob
to control the high frequency band of the as-
sociated channel’s EQ.
– Press the “Mid” button and use the Edit knob
to control the mid frequency band of the as-
sociated channel’s EQ.
– Press the “Low” button and use the Edit knob
to control the low frequency band of the asso-
ciated channel’s EQ.
If you have Vocal Tone turned on, any EQ adjust-
ments will affect the adaptive EQ. Think of these
adjustments as “fine tuning” for the Vocal Tone.
If you prefer more broad control over the EQ, turn
Vocal Tone off.
Aux
+ + + =
Monitor Mix
+ Aux
1 2 Aux
EQ
REVERB
Edit
VOICE SOLO FX-300
Master
Level Level Level
High
Mid
Low
High
Mid
Low
High
Mid
Low
Level Style Level
Voice
Cancel
Vocal
Tone
Vocal
Tone
HI Z
FULL MIX
Master
Edit
– Press the “Level” button of the Aux input and
use the Edit knob to control the volume of the
Aux signal.
If the Vocal Cancel button lights red at any
time during your performance, the Aux is clip-
ping and the level should be reduced.
– Press the “Vocal Cancel” button to switch the
Vocal Cancel feature on or off. When activat-
ed, Vocal Cancel will attempt to remove vocals
from recorded music.
The ability of Voice Cancel to remove vocals
from recorded music is highly dependent on
the original mix and other sonic qualities of the
source material.
Reverb
+ + + =
Monitor Mix
+ Aux
1 2 Aux
EQ
REVERB
Edit
VOICE SOLO FX-300
Master
Level Level Level
High
Mid
Low
High
Mid
Low
High
Mid
Low
Level Style Level
Voice
Cancel
Vocal
Tone
Vocal
Tone
HI Z
FULL MIX
Master
Edit
– Press the “Level” button in the Reverb section
and use the Edit knob to control the amount of
reverb of the associated channel.
– Press the “Style” button and use the Edit knob
to set the reverb style.
The available reverb styles are:
1. Snappy Room
2. Warehouse
3. Broadway Hall
4. Amsterdam Hall
5. Wooden Chamber
6. Bright Plate
7. Bright Chamber
8. Indoor Arena
9. Hockey Arena
The Reverb style is global for both inputs 1
and 2. This means that you cannot have a differ-
ent reverb style on each channel – but you can
have different reverb amounts.
In CH1 mode, Reverb is only applied to the sig-
nal on Input 1. Reverb will not be applied to Input
2, as the incoming signal is likely a monitor mix.