TC-Helicon HarmonyControl, Руководство по эксплуатации продукта

Страница: 8 / 24

9 99
Step 5:
Check that the LED light above the On footswitch is lit.
If it’s not, press the On footswitch.Turn up the volume
control on your guitar and play some chords. The 0
Cents LED on HarmonyControl should light with each
chord change but not every strum.
G
G
D
D
E
E
Step 6:Auto LED lit
You’re now ready to begin experimenting with guitar-
controlled harmony! Choose presets on your harmony
processor that are based on either Chord mode or
Scale mode harmony and sing while you play your
guitar. The display on HarmonyControl will show SC
(Scale) or CR (Chord) to confirm it recognizes the
preset’s harmony mode. If you see NA (Not
Applicable), this means that the preset you have loaded
is not based on Chords or Scale harmony mode and
HarmonyControl cannot control it.
Step 6: Manual LED lit
Set the MIDI input (or “receive”) channel on your
harmony processor to channel 1. This is the factory
default channel that HarmonyControl sends on. Play
your guitar and check to see that the MIDI input LED
lights on your harmony processor when you change
from one chord to the next.When set up correctly, this
LED will continue to flash while you have
HarmonyControl turned on .
Quick Start