TC Electronic G-Natural, Руководство пользователя

Страница: 23 / 35

21
MENU - LEVELS
Serial
In Serial routing with the Mic Pre parameter set to
“Vocal”, the input signal on the Mic Pre connection is
routed past the Boost, Mod and Delay blocks to the
Reverb.
Semi Parallel
In Semi Parallel routing with the Mic Pre parameter set to
“Vocal”, the input signal on the Mic Pre connection is routed
past the Boost and Mod blocks to the Reverb and Delay.
Parallel
In Parallel routing with the Mic Pre parameter set to
“Vocal” the input signal on the Mic Pre connection is
routed past the Boost block to the Reverb, Delay and
Modulation.
Vocal
Mic Pre - routing
Guitar
BOOST
MOD
DELAY
REVERB
OUT
EQ
In L
Mic/Pre
NOISE
GATE
COMP
EQ
In R
Mic/Pre
NOISE
GATE
COMP
Vocal
Mic Pre - routing
Guitar
BOOST MOD
DELAY
REVERB
OUT
EQ
In L
Mic/Pre NOISE
GATE
COMP
EQ
In R
Mic/Pre
NOISE
GATE
COMP
Vocal
Mic Pre - routing
Guitar
BOOST MOD DELAY REVERB
EQ
OUT
In L
Mic/Pre Vocal
Mic Pre - routing
Guitar
NOISE
GATE
COMP
EQ
In R
Mic/Pre
NOISE
GATE
COMP
Volume Position
Range: Pre or Post
This parameter is relevant only if you control the volume
using an external Volume/Expression pedal connected to
the Pedal input. The position of the volume parameter
can be placed “pre” delay/reverb/mod effects or “post”
delay/reverb/mod effects.
Pre: The volume control is placed in the boost block
before the input of the mod, reverb and delay effects and
these effects will therefore fade out (ring) naturally when
you set the pedal to minimum position.
Post: The volume control is placed after the mod, reverb
and delay effects and these effects will therefore be
attenuated immediately when you set the pedal to
minimum position.
Digital InGain
Use this parameter to gain the signal present on the
digital input. Adjust a low volumes and use a setting a
few dB’s lower than the where digital clipping occurs.
This will ensure best signal to noise ratio.
Dither
Range: Off, 20 bit, 16 bit or 8 bit
G-Natural operates at a bit depth of 24. If you are
feeding the G-Natural digital outputs to a digital device
with a lower bit-depth, the dither parameter must be set
according to the receiving device. As an example a
signal sent to a CD recorder should typically be dithered
to 16bit.