INSTALLING AROFLY POWER METER ON CYCLE
REAR VALVE ONLY
Before using AROFLY power meter, twist open the cap, then remove the
INSULATION TAB, from between the battery contact.
Tips:
Before installing AROFLY power meter to the rear tire valve, please inflate the
bike tires to appropriate tire pressure as marked on the tire. Suggest the road
bike to be 90~120psi (6~8bar); Mountain bike to be 35~65psi (2.4~4.5bar)
Place Wrench onto the AROFLY Base.
Twist counter-clockwise to open
AROFLY Cap.
Pull and remove Insulation Tab from
AROFLY to connect battery. Replace
the cap to AROFLY.
Insulation Tab
Installing AROFLY to the cycle rear valve: If it is a Schrader valve, please install
directly; If it is a Presta valve, please use the Presta valve adaptor first, included
in the kit, before installing the AROFLY power meter.
If it is a Presta valve, please loosen
"
the valve pin
" to the top-end of the
Presta valve shaft.
Install "
Valve Adaptor
" on Presta
valve.
Ensure the correct side of the
Adaptor to the Valve.
Twist Adaptor firmly on the Presta
valve.
If it is a Schrader valve, AROFLY can
be installed directly onto the rear
valve (no need for any adaptor).
Install AROFLY on the Adaptor.
Be sure to twist tightly to avoid
air leakage, and to ensure good
contact with valve pin.
