Wiring receiver
The receiver does not come with any connectors on-board, this is with intention to allow for flexible and
more varied setups, i.e. it is easier to add a connector than to remove a pre-soldered one.
Use normal servo-wires to either connect directly to the soldering pads/vias or use 2.54mm pin header to
mount it to a motherboard. The antennas use a U.FL connector. Use heat-shrink tubing to protect the
receiver.
Connect the antenna with the U.FL connector to the socket on the receiver. To ensure that it does not
disconnect or unseat, run the coax cable across the receiver board over to the servo channel end and
secure it with the heat shrink-tubing.
2
