1644259E (406159)
2020-09-30
14
1644259E (406159)
2020-09-30
15
INSTALL GREASE ZERKS AND LUBRICATE
Lubricate all fittings at regular intervals, at least every 150
cycles or every two months. The grease fittings are located
as follows:
HOIST
A. Lower Crosstube .........................
2 fittings
B. Upper Crosstube ..........................
1 fittings
C. Cylinder Base Pivot Tube ...........
1 fitting
NOTE: The crosshead, center hinge and body pivot are
equipped with composite bearings which do not need
lubrication.
FIG. 11
B
C
A
BODY PIVOT
CROSSHEAD
CENTER
HINGE
BODY
F. Trip Lever - Side Pivot .................
1 fitting
G. Trip Lever - Rear Pivot ................
2 fittings
H. Side Shaft Pivot............................
3 fittings
(dump through side)
I. Side Hook Pivot ..........................
2 fittings
(dump through side)
J. Tailgate Upper Hinge ...................
2 fittings
K. Rear Latch Cross Shaft ................
2 fittings
L. Side Hinge Pivot .........................
3 fittings
(fold down side)
M. Side Shaft Pivot ...........................
4 fittings
(fold down side)
N. Side Hinge Pivot ..........................
2 fittings
(dump thru side)
SUBFRAME
O. Side Hinge ....................................
1 fitting
P. Rear Hinge ...................................
1 fitting
Q. Left/Rear Hinge ...........................
2 fittings
R. Side Hinge Saddle ........................
1 fitting
S. Rear Hinge Saddle .......................
1 fitting
T. Hinge Control Shaft .....................
3 fittings
U. Side Latch Control Shaft ..............
2 fittings
V Hoist Pivot ...................................
1 fitting
